Back to Results

34' Sabre 34 Mark I

$37,000

ANSHIN is a 1983 Sabre 34 yacht, the ?MK I? series.   It is a high-quality yacht with a handsome, classic design.    She has a diesel engine.   When the Sabre 34 was new, it was a relatively high priced sailboat, as befits the premium workmanship and materials.   Sabres are built in Maine.  The Sabre 34 MK I is a solid example of a high quality Sabre Yacht.  Known for their excellent sea-keeping abilities and stout construction, they were engineered and built to last for many years.

  • Make: Sabre
  • Model: 34 Mark I
  • Year: 1981
  • Length: 34ft
  • Name: ANSHIN
  • Hull Material: Fiberglass
  • Engine/Fuel Type:
  • Located In: Emeryville, CA
  • Category: Sail
  • Class: Cruisers
  • Keel: Fin Keel
  • Designer: Roger Hewson
  • Builder: Sabre Yachts
  • LOA: 33.67 feet
  • LWL: 26.25 feet
  • Beam: 10.5 feet
  • Max Draft: 5.5 feet
  • Ballast: 1600 pounds
  • Displacement: 11400 pounds
  • Total Engines: 1
  • Engine 1
  • EngineMake: Westerbeke
  • EngineModel: Four Cylinder Model 30
  • EngineYear: 1981
  • EngineFuel: diesel
  • PropellerType: 2 Blade, Bronze
  • Fuel Tank Capacity: 20 gallon
  • Fuel Tank Count: 1
  • Water Tank Capacity: 38 gallon
  • Water Tank Count: 1
  • Heads: 1

Additional Descriptions

Construction
Sabre 34 Mark I was produced with a balsa-cored hull. The hull was hand laid, using mat and roving with polyester resin- The decks are cored with 3/8-inch and half-inch end grained balsa, although plywood is used in high-load areas. The hull-and-deck joint is an inward flange and through-bolted. F Floors, knees, bulkheads and most structural members are well supported. The external lead ballast is fastened with stainless keel bolts, which are supported by a reinforced fiberglass fillet. The nuts are visible in the bilge.  255 Sabre 35 boats were built by Sabre Yachts
Sails & Rigging
The Sabre 34 carries 507 square feet of sail area Winches:  (2) Lewmar # 44 Self Tailing cockpit  Winches:  (3) Lewmar #16 cabin top  Winches:  (1) Lewmar #16 self tailing cabin tio Winches:  (2) Lewmar #40 cockpit Roller furling jib 140% Main Sail Spinaker
Electrical
Circuit breaker panel for 12V and 110V power Shore power cord and 110V 30 Amp inlet fixture 3 x Group 27 wet cell batteries Pro Mariner "Pro-Tech 4" Battery charger
Galley
Two burner CNG stove with oven Refrigeration 12V Adler Barbour Water tanks 44 Gallon Polyethylene Double Stainless sinks Hot and Cold pressure water 6 gallon Hot Water Heater Sureflow 3.3 gpm 12V water pressure pump
Electronics
VHF Icom IC-M22 with remote microphone Autopilot Autohelm 5000 Jensen stereo sound system Datamarine Depth Sounder Furuno Radar Uniden Mystic GPS Datamarine Knot Meter Raymarine Wind Speed/Direction

Additional Features

  • TOTAL SAIL AREA
  • • 507.00
Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. Buyer should assume that items on the vessel at the time of viewing, but not specifically listed on this specification sheet, are not included with the sale of the yacht, and should instruct his agents, or his surveyors to investigate such details as the buyer desires validated. Buyer assumes responsibility to verify all speeds, consumptions, capacities and other measurements contained herein and otherwise provided, and agrees to instruct his surveyor to confirm such details prior to purchase. This vessel is subject to sale, price and inventory changes, and withdrawal from market without notice.

Broker Details

Bill Adams

Yacht & Ship Sales
bill@rubiconyachts.com
415-425-5099 - mobile
415-484-1300 - office
3300 Powell St., Ste 105
Emeryville, CA 94608

Contact Bill Adams

    Your Email (required)


    Your Phone

    Comments

    For additional information and viewing of this fine quality yacht please contact listing agent Bill Adams. I am always available on my mobile phone at 4154255099 or e-mail me at bill@rubiconyachts.com