ANGELIQUEA

Accommodations

ANGELIQUEA has berths for 8 persons. The forward stateroom has a double bed, the second cabin is a single, the salon settee converts to a double bed, the pilothouse has a settee that can accommodate the off watch crew and the master stateroom has a center line queen bed. There are two hatches to topside and the main entry hatch to pilot house. There are two steering stations, main in pilot house and one outside before mizzen mast.

From bow to stern. Chain locker and storage to 1st bulkhead, then 1st stateroom 1 single bed on port side and the forward head with laundry and shower on the starboard side, to 2nd bulkhead, on port side storage, on starboard side sail storage and lines, 3rd bulkhead and on port side a full size workroom/machine shop with bench, vise and tool/parts storage, on starboard side fireplace and salon settee, then 4th bulkhead on port pantry, food storage and galley, on port side medium freezer and large capacity freezer, electric panel and controls for 12 volt and 24 volt systems (mid ship). From the galley upstairs (stairs are removable to access front of engine room) to pilot house, below the pilot house is the engine room (accessible from hatch in pilot house) engine room is also accessible from the machine shop on starboard side and next to the pantry door on the port side. In the pilot house there is an extra suspended berth for the man on watch. From the pilot house on the starboard side are stairs going below, aft to master stateroom. On starboard side, directly below the stairs from the pilot house to the deck, is a captain's desk, chart table and seat mid-section of the master stateroom, on the port side is the master stateroom head and a cedar lined walk closet. There is a queen bed in center of master stateroom with storage below. On starboard side aft is a small seat, and small berth or storage area. Across the stern behind the master stateroom bed, is the exhaust and steering cable compartment, visible through clear wood trimmed doors. On port side aft is a small berth, or storage area.

Additional Information

This design was originally based on the very successful Roberts 53 and is assured of acceptance by those builders who require a larger boat either for charter work or for extended cruising with a large party of guests. To date over 200 of these boats have been completed in Steel and Fiberglass.

Electrical

• 120V Shore power inlet and cable
• 2 x Blue Seas 120/v Breaker Panels
• 1 x Blue Seas 12V Breaker Panels
• All lighting is LED
• Nav Lights at deck level and Mast Top Tri-color
• 9 KW Onan Diesel genset in a sound box.
• 1650 Watt Solar Array 6 panels and Solar Controller Installed 2012
• 50 Amp Battery Charger
• 10 Amp Battery Charger
• 4 House Batteries, 4 Start Batteries, 1 aft battery for Davit, 1 battery for Windlass
• 2 Galvanic Isolators with Isolation Transformers

Galley

• Large Galley with centerline prep island
• Full size domestic refrigerator/Freezer
• 6' x 6' Pantry with 2 x chest freezers
• NEW 11 gallon Force 10 water heater

Mast and Sails

• Stainless Steel Masts and boom
• Roller Furling 140% Genoa New 4/2012
• 1 140% Genoa not mounted
• 1 Spare Mainsail
• 1 Clubfoot Jib
• Mainsail on stainless mast and boom
• Mizzen sail on stainless mast and boom

Additional Equipment

• 600 Gallon / Day Village Marine Water Maker 3/2013
• 2 windlass 1 forward with massive roller winch. and 1 aft
• 3 Anchors 1 Danforth, 1 Plow, 1 Delta
• Dickinson Diesel Cabin Heater 1/2013
• 2 Lewmar/Simpson Lawrance Windlass
• Dinghy Davits - 12V Electric Winch
• Dinghy 12' (Not Title/Registration)
• Tohatsu 20hp 4 cycle
• 2 Air conditioning Units Mermaid 6,500 & 12,500 BTU
• 1 Air Conditioning/Heater Cabinmate 16,000 BTU
• Two 3 blade props, one spare. 1 x SS and 1 x Bronze

Electronics and Navigation

• Furono Radar 36 mile
• Chartplotter Nav-Net C-Map Split Screen
• Raymarine Autopilot
• AIS Transiever
• Uniden VHF
• Single Sideband with ICOM grounding Antenna
• Garmin GPS
• Electronics updated 2013

Recent upgrades and improvements

• Complete interior remodel with authentic teak 2023
• New Propshaft and dripless shaft seal 2015
• Tune-up Outboard with New coil, plugs, impeller and service 7/23
• Main engine maintenance, oil change with filters and impeller 7/23
• Maintenance genset with oil/filters/impeller 7/23
• Upgrade entire boat wiring system and panels 11/2012

Shop Work Bench

• 10 x 6 Workshop
• Workbench
• Drill Press
• Grinding Wheels
• Tool Storage
• Parts Storage

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. Buyer should assume that items on the vessel at the time of viewing, but not specifically listed on this specification sheet, are not included with the sale of the yacht, and should instruct his agents, or his surveyors to investigate such details as the buyer desires validated. Buyer assumes responsibility to verify all speeds, consumptions, capacities and other measurements contained herein and otherwise provided, and agrees to instruct his surveyor to confirm such details prior to purchase. This vessel is subject to sale, price and inventory changes, and withdrawal from market without notice.